D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 50 Log Configuration
50-7
14
log alert
15
clock daemon
16
local use 0 (local0)
17
local use 1 (local1)
18
local use 2 (local2)
19
local use 3 (local3)
20
local use 4 (local4)
21
local use 5 (local5)
22
local use 6 (local6)
23
local use 7 (local7)
The default device value of our products is 23.
50.2.9 Configuring the Source Address of
Log Packets
By default, the source address of the log packets sent to the syslog server is the address of
the interface that sends the packets. It is possible to fix the source address for all log packets
through commands.
It is possible to directly set the source IP address of the log packets or the remote port of the
log packets.
To configure the source address of the log packets, run the following command in the global
configuration mode:
Command
Function
DGS-3610(config)# logging source interface
interface-type interface-number
Configure the source port of log information
DGS-3610(config)# logging source ip
A.B.C.D
Configure the source IP address of log messages
50.2.10 Setting the Function of Sending User
Logs
By default, no log is output when a user logs in or out and executes configuration commands.
To output user login/logoff logs or configuration command logs, execute the following
commands in the global configuration mode:
Command
Function
DGS-3610(config)# logging userinfo
Set user login/logoff log.
DGS-3610(config)# logging userinfo
command-log
Send a log when a configuration command is
executed

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English