D-Link xStack DGS-3610 Series User Manual

Chapter 2 Configuration of Switch Basic Management DGS-3610 Series Configuration Guide
2-4
DGS-3610(config)# enable secret level 1 0 test
DGS-3610(config)# end
Enter the level 1, you can see the command and its subcommand:
DGS-3610# disable 1
DGS-3610> reload ?
at reload at a specific time/date
cancel cancel pending reload scheme
in reload after a time interval
<cr>
The following is the configuration process that restores the privilege of the reload command
and its subcommand as the default value:
DGS-3610# configure terminal
DGS-3610(config)# privilege exec all reset reload
DGS-3610(config)# end
Enter the level 1, the privilege of command will be taken back.
DGS-3610# disable 1
DGS-3610> reload ?
% Unrecognized command.
2.2.7 Configuring Line Password
Protection
Our products suppors password authentication for remote logons (such as TELNET). A line
password is required for the protection purpose. Execute the following command in the line
configuration mode:
Command
Purpose
DGS-3610(config-line)# password
password
Specify the line password
DGS-3610(config-line)# login
Enable the line password protection
Note
If no logon authentication is configuration, the line layer password
authentication will be ignored even when the line password is configured.
The logon authentication will be described in the next section.
2.2.8 Supporting Session Locking
Our products allow you to lock the session terminal temporarily using the lock command, so
as to prevent access. To use the function of locking the session terminal, enable the terminal
locking function in the line configuration mode, and lock the terminal using the lock
command in the EXEC mode of the corresponding terminal:

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English