D-Link xStack DGS-3610 Series User Manual

Chapter 33 IPV6 Tunnel Configuration DGS-3610 Series Configuration Guide
33-10
Command
Meaning
show ipv6 route
View the IPv6 router table.
1. View the information of a tunnel interface.
DGS-3610# show interface tunnel 1
Tunnel 1 is up, line protocol is Up
Hardware is Tunnel, Encapsulation TUNNEL
Tunnel source 192.168.5.215 , destination 192.168.5.204
Tunnel protocol/transport IPv6/IP
Tunnel TTL is 9
Tunnel source do conformance check set
Tunnel source do ingress filter set
Tunnel destination do safety check not set
Tunnel disable receive packet not set
2. View the IPv6 information of a Tunnel interface.
DGS-3610# show ipv6 interface tunnel 1
interface Tunnel 1 is Up, ifindex: 6354
address(es):
Mac Address: N/A
INET6: fe80::3d9a:1601 , subnet is fe80::/64
Joined group address(es):
ff02::2
ff01::1
ff02::1
ff02::1:ff9a:1601
INET6: 3ffe:4:0:1::1 , subnet is 3ffe:4:0:1::/64
Joined group address(es):
ff02::2
ff01::1
ff02::1
ff02::1:ff00:1
MTU is 1480 bytes
ICMP error messages limited to one every 100 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 seconds<240--160>
ND router advertisements live for 1800 seconds

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English