EasyManua.ls Logo

D-Link xStack DGS-3610 Series

D-Link xStack DGS-3610 Series
703 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 33 IPV6 Tunnel Configuration DGS-3610 Series Configuration Guide
33-18
interface Tunnel 2
tunnel mode ipv6ip 6to4
ipv6 enable
tunnel source GigabitEthernet 0/1
# Configure the route to the 6to4 tunnel
ipv6 route 2002::/16 Tunnel 2
# Configure the routeto the 6to4 relay router RT-D to access the Cernet network
ipv6 route ::/0 2002:d3a2::0901::1
RT-B configuration:
# Connect the interfaces of the Internet
interface GigabitEthernet 0/1
no switchport
ip address 211.162.5.1 255.255.255.0
# Connect interface 1 of the IPv4 network inside the site
interface FastEthernet 0/1
no switchport
ip address 192.168.10.1 255.255.255.0
# Connect interface 2 of the IPv4 network inside the site
interface FastEthernet 0/2
no switchport
ip address 192.168.20.1 255.255.255.0
# Configure isatap interface Tunnel 1
tunnel mode ipv6ip isatap
tunnel source FastEthernet 0/1
ipv6 address 2002:d3a2:0501:1::/64 eui-64
no ipv6 nd suppress-ra
# Configure 6to4 tunnel interface
interface Tunnel 2
tunnel mode ipv6ip 6to4
ipv6 enable
tunnel source GigabitEthernet 0/1
# Configure the route to the 6to4 tunnel
ipv6 route 2002::/16 Tunnel 2
# Configure the routeto the 6to4 relay router RT-D to access the Cernet network
ipv6 route ::/0 2002:d3a2::0901::1
RT-C configuration:
# Connect the interfaces of the Internet

Table of Contents

Other manuals for D-Link xStack DGS-3610 Series

Related product manuals