Enabling PIM-SM (required)
Configuring the Hello message sending interval (optional)
Configuring PIM-SM neighbor filtering (optional)
Configuring the priority of specified device DR (optional)
Configuring the candidate BSR status (optional)
Configuring static RP (optional)
Configuring candidate RP (optional)
Configuring particular source multicast (optional)
Configuring flood/prune time for the timer (optional)
Configuring the speed limit on the sending of registered packets (optional)
Configuring reachability detection for registered packets (optional)
Configuring the source address of registration packets (optional)
Configuring the RP suppression time (optional)
Configuring the time of the KAT timer (optional)
Switching the last-hop device from shared tree to the shortest path tree (optional)
Switching the last-hop device from shared tree to the shortest path tree in multiple
multicast groups (optional)
Show the status of the PIM-SM (optional)
35.6.22.1 Enabling Multicast Routing
The multicast routing must be enabled before the multicast packets can be transmitted, and
so that enabling the PIM-SM is meaningful.
35.6.22.2 Enabling PIM-SM
The PIM-SM must be enabled on each interface. The device can interact with other devices
for PIM-SM control messages, maintain and update multicast routing tables and forward
multicast packets only after PIM-SM is enabled on the interface.
To configure the PIM-SM on the interface, execute the following command in the interface
mode:
To Next Page
Loading...
Need help?
General