D-Link xStack DGS-3610 Series

DGS-3610 Series Configuration Guide Chapter 4 Configuration of System Upgrade and Maintenance
4-3
Figure 4-2
Command
Function
DGS-3610# copy xmodem flash:filename
Download a file from the host to the device and name
it filename.
In the CLI command mode, upload the files by performing the following steps:
Prior to upload, firstly log in to the out-band management interface of the device through the
Windows Super Terminal. Then, upload the files by using following commands in the
privileged mode. Finally, select the ―Receive File‖ from the ―Transfer‖ menu on the Windows
Super Terminal on the local host. It‘s shown in the Figure 4-3:
Figure 4-3
In the pop-up dialog box, select the storage location for uploading the files and select the
―Xmodem‖ as the reception protocol. Click ―Receive‖, the name of the files locally stored will
be further displayed on the Windows Super Terminal. Click ―OK‖ to receive the files. The
operaton is shown below: