Enterasys SecureStack C2 User Manual

reset
SecureStack C2 Configuration Guide 3-47
Commands
reset
Usethiscommandtoresettheswitchwithoutlosinganyuser‐definedconfigurationsettings.
Syntax
reset [unit]
Parameters
Defaults
IfnounitIDisspecified,theentiresystemwillbereset.
Mode
Switchcommand,read‐write.
Usage
ASecureStackC2switchcanalsoberesetwiththeRESETbuttonlocatedonitsfrontpanel.For
informationonhowtodothis,refertotheSecureStackC2InstallationGuideshippedwithyour
switch.
Examples
Thisexampleshowshowtoresetthesystem:
C2(su)->reset
Are you sure you want to reload the stack? (y/n) y
Saving Configuration to stacking members
Reloading all switches.
Thisexampleshowshowtoresetunit1:
C2(su)->reset 1
Are you sure you want to reload the switch? (y/n) y
Reloading switch 1.
This switch is manager of the stack.
STACK: detach 3 units
For information about... Refer to page...
reset 3-47
clear config 3-48
unit (Optional)Specifiesaunittobereset.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English