Configuring IGMP on Routing Interfaces
SecureStack C2 Configuration Guide 11-9
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearallIGMPsnoopingentries:
C2(su)->clear igmpsnooping
Are you sure you want to clear all IGMP snooping entries? (y/n) y
IGMP Snooping Entries Cleared.
Configuring IGMP on Routing Interfaces
Purpose
ToconfigureIGMPonroutinginterfaces.
Commands
Router: The commands covered in this section can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “Enabling Router
Configuration Modes” on page 15-2.
For information about... Refer to page...
ip igmp 11-10
ip igmp enable 11-10
ip igmp version 11-11
show ip igmp interface 11-11
show ip igmp groups 11-12
ip igmp query-interval 11-12
ip igmp query-max-response-time 11-13
ip igmp startup-query-interval 11-14
ip igmp startup-query-count 11-14
ip igmp last-member-query-interval 11-15
ip igmp last-member-query-count 11-15
ip igmp robustness 11-16
To Next Page
Loading...
Need help?
General