Enterasys SecureStack C2

set switch movemanagement
SecureStack C2 Configuration Guide 2-11
set switch movemanagement
Usethiscommandtomovemanagementswitchfunctionalityfromoneswitchtoanother.
Syntax
set switch movemanagement fromunit tounit
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtomovemanagementfunctionalityfromswitch1toswi tch2:
C2(su)->set switch movemenagement 1 2
Moving stack management will unconfigure entire stack including all interfaces.
Are you sure you want to move stack management? (y/n) y
set switch member
Usethiscommandtoaddavirtualmembertoastack.Thisallowsyoutopreconfigureaswitch
beforethephysicaldeviceisactuallyaddedtothestack.
Syntax
set switch member unit switch-id
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Referto“CreatingaVirtualSwitchConfiguration”onpage2‐4formoreinformationabouthowto
addavirtualswitchtoastack.
fromunit Specifiestheunitnumberofthecurrentmanagementswitch.
tounit Specifiestheunitnumberofthenewly‐designatedmanagementswitch.
unit Specifiesaunitnumberfortheswitch.
switch‐id SpecifiesaswitchID(SID)fortheswitch.SIDscanbedisplayedwiththe
showswitchswitchtypecommand.