Enterasys SecureStack C2 - Show Cos Port-Config

show cos port-config
SecureStack C2 Configuration Guide 9-23
Usage
CoSIRLportgroupsareidentifiedbygroupnumberandthetypeofportsinthegroup,inthe
formofgroup#.port‐type.TheIRLportgroup0.0existsbydefault.Thisdefaultportgroupcannot
beremovedandallphysicalportsinthesystemareassignedtoit.Up
tosevenadditionalport
groups(1through7)canbeconfigured.Currently,onlyoneporttype(type0)issupported.This
porttypesupports100limiters.
Additionalportgroupsmaybecreatedforflexibility.Portsassignedtoanewportgroupmustbe
mutuallyexclusivefromtheotherportgroupentries—ports
areautomaticallyremovedfrom the
defaultportgroup—andmustbecomprisedofthesameporttypeasdefinedbytheportgroup.
Thecreationofadditionalportgroupscouldbeusedtocombinesimilarportsbytheirfunctionfor
flexibility.Forinstance,portsassociatedtouserscanbeaddedtoa
portgroupcalled“Users”and
portsassociatedtouplinkportscanbeaddedtoaportgroupcalled“Uplink.”Usingtheseport
groups,asingleclassofservicecanassigndifferentratelimitstoeachportgroup.“User”ports
canbeassignedoneratelimit,while“Uplink”portscanbeassigned
another.DFEsupportsa
maximumof8portgroupsperCoSfunction(IRL).
Thecommandshowcosport‐configdisplayseachIRLportgroupconfiguredbygroupandtype,
withthegroupnameandassociated(assigned)ports.Thecommandshowcosport‐typedisplays
theavailableinbound ratelimitingresources
fortheporttype.
Example
Thisexampleconfigurestwoportgroups,oneforuserportsandoneforuplinkportsandassign
portstothegroups.Portgroup1.0willrepresentuserports,group2.0willrepresentuplinkports.
C2(su)->set cos port-config irl 1.0 name Users ports ge.1.1-46
C2(su)->set cos port-config irl 2.0 name Uplink ports ge.1.47-48
show cos port-config
Usethiscommandtoshowinboundratelimitinggroupsandtheassignedports.
Syntax
show cos port-config [irl group-type-index]
Parameters
Defaults
Theshowcosport‐configcommandbyitselfwillshowallPortGroups.
Mode
Switchcommand,read‐only.
irl (Optional)Specifiesthatinboundratelimitingconfigurationinformation
shouldbedisplayed.
group‐type‐index (Optional)Showassignedportsforaspecificportgroup.Validentriesare
intheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
canrangefrom0to1,althoughonlyporttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.