Enterasys SecureStack C2

Setting Speed and Duplex Mode
SecureStack C2 Configuration Guide 5-9
Parameters
Defaults
Ifnameisnotspecified,thealiasassignedtotheportwillbecleared.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtoassignthealias“A d m i n ” toge.3.3:
C2(rw)->set port alias ge.3.3 Admin
Thisexampleshowshowtoclearthealias forge.3.3:
C2(rw)->set port alias ge.3.3
Setting Speed and Duplex Mode
Purpose
ToreviewandsettheoperationalspeedinMbpsandthedefaultduplexmode:Half,forhalf
duplex,orFull,forfullduplexforoneormoreports.
Commands
show port speed
Usethiscommandtodisplaythedefaultspeedsettingononeormoreports.
port‐string Specifiestheporttowhichanalias willbeassigned.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage5‐2.
name (Optional)Assignsan
aliasnametotheport.Ifthealiasnamecontains
spaces,thetextstringmustbesurroundedbydoublequotes.Maximum
lengthis60characters.
Note: These settings only take effect on ports that have auto-negotiation disabled.
For information about... Refer to page...
show port speed 5-9
set port speed 5-10
show port duplex 5-11
set port duplex 5-14