To Next Page

To Previous Page

set summertime date

SecureStack C2 Configuration Guide 3-17

Mode

Switchcommand,read‐only.

Example

Thisexampleshowshowtoenabledaylightsavingstimefunction:

C2(su)->set summertime enable

set summertime date

Usethiscommandtoconfigurespecificdatestostartandstopdayl ightsavingstime.These

settingswillbenon‐recurringandwillhavetoberesetannually.

Syntax

set summertime date start_month start_date start_year start_hr_min end_month

end_date end_year end_hr_min [offset_minutes]

Parameters

Defaults

Ifanoffsetisnotspecified,nonewillbeapplied.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtosetadaylightsavingstimestartdateofApril4,2004at2a.m.andan

endingdateofOctober31,2004at2a.m.withanoffsettimeofonehour:

C2(su)->set summertime date April 4 2004 02:00 October 31 2004 02:00 60

set summertime recurring

Usethiscommandtoconfigurerecurringdaylightsavingstimesettings.Thesesettingswillstart

andstopdaylightsavingstimeatthespecifieddayofthemonthandhoureachyearand willnot

havetoberesetannually.

start_month Specifiesthemonthoftheyeartostartdaylightsavingstime.

start_date Specifies

thedayofthemonthtostartdaylightsavingstime.

start_year Specifies theyeartostartdaylightsavingstime.

start_hr_min Specifiesthetimeofdaytostartdaylightsavingstime.Formatishh:mm.

end_month Specifiesthemonthoftheyeartoenddaylightsavingstime.

end_date Specifiesthedayofthemonthto

enddaylightsavingstime.

end_year Specifiestheyeartoenddaylightsavingstime.

end_hr_min Specifiesthetimeofdaytoenddaylightsavingstime.Formatishh:mm.

offset_minutes (Optional)Specifiestheamountoftimeinminutestooffsetdaylight

savingstimefromthenon‐daylightsavingstimesystemsetting.Valid

valuesare1‐

1440.

Enterasys SecureStack C2 User Manual

Questions and Answers: