To Next Page

To Previous Page

show snmp persistmode

SecureStack C2 Configuration Guide 3-37

show snmp persistmode

Usethiscommandtodisplaytheconfigurationpersistencemodesetting.

Syntax

show snmp persistmode

Parameters

None.

Defaults

None.

Mode

Switchcommand,read‐only.

Usage

Bydefault,themodeissetto“autosave,”whichautomaticallysavesconfigurationchangesat

specificintervals.Ifthemodeissetto“manua l,” configurationcommandsareneverautomatically

saved.Inordertomakeconfigurationchangespersistentwhenthemodeismanual,thesave

configcommandmustbeissuedasdescribed

in“Configuration PersistenceMode”onpage3‐36.

Example

Thisexampleshowshowtodisplaytheconfigurationpersistencemodesetting.Inthiscase,

persistencemodeissetto“manual”,whichmeansconfigurationchangesarenotbeing

automaticallysaved.

C2(su)->show snmp persistmode

persistmode is manual

set snmp persistmode

Usethiscommandtosettheconfigurationpersistencemode,whichdetermineswhetheruser‐

definedconfigurationchangesaresavedautomatically,orrequireissuingthesaveconfig

command.See“ConfigurationPersistenceMode”onpage3‐36formoreinformation.

Syntax

set snmp persistmode {auto | manual}

Parameters

auto Setstheconfigurationpersistencemodetoautomatic.Thisisthedefault

state.

manual Setstheconfigurationpersistencemodetomanual.Inordertomake

configurationchangespersistent,thesaveconfigcommandmustbe

issuedasdescribedin“saveconfig”onpage3‐38.Thismodeisusefulfor

revertingback

tooldconfigurations.

Enterasys SecureStack C2 User Manual

Questions and Answers: