Enterasys SecureStack C2

show rmon filter
SecureStack C2 Configuration Guide 13-17
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearRMONchannelentry2:
C2(rw)->clear rmon channel 2
show rmon filter
UsethiscommandtodisplayoneormoreRMONfilterentries.
Syntax
show rmon filter [index index | channel channel]
Parameters
Defaults
Ifnooptionsarespecified,informationforallfilterentrieswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayallRMONfilterentriesandchannelinformation:
C2(rw)->show rmon filter
Index= 55508 Channel Index= 628 EntryStatus= valid
----------------------------------------------------------
Data Offset 0 PktStatus 0
PktStatusMask 0 PktStatusNotMask 0
Owner ETS,NAC-D
-----------------------------
Data
ff ff ff ff ff ff
-----------------------------
DataMask
ff ff ff ff ff ff
-----------------------------
DataNotMask
00 00 00 00 00 00
index Specifiesthechannelentrytobecleared.
indexindex|
channelchannel
(Optional)Displaysinformationaboutaspecificfilterentry,oraboutall
filterswhichbelongtoaspecificchannel.