Enterasys SecureStack C2 - Set Lldp Port Location-Info; Set Lldp Port Tx-Tlv

set lldp port location-info
4-26 Discovery Protocol Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleenablestransmitting LLDP‐MEDtrapsonportsge.1.1throughge.1.6.
C2(rw)->set lldp port med-trap enable ge.1.1-6
set lldp port location-info
UsethiscommandtoconfigureLLDP‐MEDlocationinformationonaportorrangeofports.
Currently,onlyEmergencyCallServices(ECS)EmergencyLocationIdentificationNumber(ELIN)
issupported.
Syntax
set lldp port location-info elin elin-string port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Afteryouconfigurealocationinformationvalue,youmustalsoconfiguretheporttosendthe
LocationInformationTLVwiththesetlldpporttx‐tlvcommand.Thisexampleconfiguresthe
ELINidentifier5551234567onports
ge.1.1throughge.1.6andthenconfigurestheportstosend
theLocationInformationTLV.
C2(rw)->set lldp port location-info 5551234567 ge.1.1-6
C2(rw)->set lldp port tx-tlv med-loc ge.1.1-6
set lldp port tx-tlv
UsethiscommandtoselecttheoptionalLLDPandLLDP‐MEDTLVstobe transmittedin
LLDPDUsbythespecifiedportorports.Usetheshowlldpportlocal‐infocommandtodisplay
thevaluesoftheseTLVsfortheport.
elin SpecifiesthattheECSELINdataformatistobe
used.
elin‐string Specifiesthelocationidentifier.Valuecanbefrom10to25numerical
characters.
port‐string Specifiestheportorrangeofportstobeaffected.