Enterasys SecureStack C2

set port speed
5-10 Port Configuration
Syntax
show port speed [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,defaultspeedsettingsforallportswilldisplay.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythedefaultspeedsettingfor1‐GigabitEthernetport14in
slot 3:
C2(su)->show port speed ge.3.14
default speed is 10 on port ge.3.14.
set port speed
Usethiscommandtosetthedefaultspeedofoneormoreports.Thissettingonlytakeseffecton
portsthathaveauto‐negotiationdisabled.
Syntax
set port speed port-string {10 | 100 | 1000}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetge.3.3toaportspeedof10 Mbps:
C2(su)->set port speed ge.3.3 10
port‐string (Optional)Displaysdefaultspeedsetting(s)for specificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage5‐2.
port‐string Specifiestheport(s)forwhichtoaspeedvaluewillbeset.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“Port
StringSyntaxUsedintheCLI”onpage5‐2.
10|100|1000 Specifiestheportspeed.Validvaluesare:10 Mbps,100 Mbps,
or
1000 Mbps.