Enterasys SecureStack C2 - Clear Lacp; Set Lacp Static

clear lacp
SecureStack C2 Configuration Guide 5-39
Example
ThisexampleshowshowtosettheLACPadminkeyto2000forLAGport6:
C2(su)->set lacp aadminkey lag.0.6 2000
clear lacp
UsethiscommandtoclearLACPsystempriorityoradminkeysettings.
Syntax
clear lacp {[asyspri] [aadminkey port-string]}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtocleartheactor adminkeyforLAGport6:
C2(su)->clear lacp aadminkey lag.0.6
set lacp static
Usethiscommandtodisableorenablestaticlinkaggregation,ortoassignoneormoreunderlying
physicalportstoaLinkAggregationGroup(LAG).
Syntax
set lacp static {disable | enable} | lagportstring [key] port-string
Parameters
asyspri Clearssystem priority.
aadminkeyport‐string Resetsadminkeysforoneormoreportstothedefaultvalueof32768.
disable|enable Disablesorenablesstaticlinkaggregation.
lagportstring SpecifiestheLAGaggregatorporttowhichnewportswillbeassigned.
key (Optional)Specif iesthenewmemberportandLAGportaggregator
adminkeyvalue.Onlyportswithmatchingkeysareallowedto
aggregate.Validvaluesare0‐65535.
Note: This key value must be unique. If ports other than the desired
underlying physical ports share the same admin key value, aggregation
will fail or undesired aggregations will form.
port‐string Specifiesthememberport(s)toaddtotheLAG.For adetaileddescription
ofpossibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage5‐2.