Enterasys SecureStack C2 User Manual

clear arp-cache
SecureStack C2 Configuration Guide 16-11
clear arp-cache
Usethiscommandtodeleteallnonstatic(dynamic)entriesfromtheARPtable.
clear arp-cache
Parameters
None.
Mode
PrivilegedEXEC:C2(su)‐>router#
Defaults
None.
Example
ThisexampleshowshowtodeletealldynamicentriesfromtheARPtable:
C2(su)->router#clear arp-cache
Configuring Broadcast Settings
Purpose
ToconfigureIPbroadcastsettings.Bydefault,interfacesontheSecureStackC2donotforward
broadcastpackets.
Commands
ip directed-broadcast
UsethiscommandtoenableordisableIPdirectedbroadcastsonaninterface.Bydefault,
interfacesontheSecureStackC2donotforwarddirectedbroadcasts.Thenoformofthis
commanddisablesIPdirectedbroadcastontheinterface.
Syntax
ip directed-broadcast
no ip directed-broadcast
Parameters
None.
For information about... Refer to page...
ip directed-broadcast 16-11
ip helper-address 16-12

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English