Enterasys SecureStack C2

show tftp settings
SecureStack C2 Configuration Guide 3-43
Example
Thisexampleshowshowtodeletethe“Jan1 _2004.cfg”configurationfile:
C2(su)->delete configs/Jan1_2004.cfg
show tftp settings
UsethiscommandtodisplayTFTPsettingsusedbytheswitchduringdatatransfersusingTFTP. 
Syntax
show tftp settings
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
TheTFTPtimeoutvaluecanbesetwiththesettftptimeo utcommand.TheTFTPretryvaluecan
besetwiththesettftpretrycommand.
Example
Thisexampleshowstheoutputofthiscommand.
C2(ro)->show tftp settings
TFTP packet timeout (seconds): 2
TFTP max retry: 5
set tftp timeout
UsethiscommandtoconfigurehowlongTFTPwillwaitforareplyofeitheranacknowledgement
packetoradatapacketduringadatatransfer.
Syntax
set tftp timeout seconds
Parameters
Defaults
None.
seconds Specifiesthenumberofsecondstowaitforareply.Thevalidrangeis
from1to30seconds.Defaultvalueis2seconds.