Enterasys SecureStack C2 User Manual

Packet Capture Commands
SecureStack C2 Configuration Guide 13-19
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearRMONfilterentry1:
C2(rw)->clear rmon filter index 1
Packet Capture Commands
Notethatpacketcapturefilterissamplingonlyanddoesnotguarantee receiptofback‐to‐back
packets.
Purpose
TodisplayRMONcaptureentries,configure,enable,ordisablecaptureentries,andclearcapture
entries.
Commands
show rmon capture
UsethiscommandtodisplayRMONcaptureentriesandassociatedbuffercontrolentries.
Syntax
show rmon capture [index [nodata]]
indexindex|
channelchannel
Clearsaspecificfilterentry,orallentriesbelongingtoaspecificchannel.
For information about... Refer to page...
show rmon capture 13-19
set rmon capture 13-20
clear rmon capture 13-21

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English