Enterasys SecureStack C2

timers spf
SecureStack C2 Configuration Guide 17-15
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Usage
Thepriorityvalueiscommunicatedbetweenroutersbymeansofhellomessagesandinfluences
theelectionofadesignatedrouter.
Example
ThisexampleshowshowtosettheOSPFpriorityto20fortheVLAN1interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip ospf priority 20
timers spf
UsethiscommandtochangeOSPFtimervaluestofine‐tunetheOSPFnetwork.Thenoformof
thiscommandrestoresthedefaulttimervalues(5secondsfordelayand10secondsforholdtime).
Syntax
timers spf spf-delay spf-hold
no timers spf
Parameters
Defaults
None.
Mode
Routerconfiguration:C2(su)‐>router(Config‐router)#
Example
ThisexampleshowshowtosetSPFdelaytimeto7secondsandholdtimeto3:
C2(su)->router(Config)#router ospf 1
C2(su)->router(Config-router)#timers spf 7 3
number Specifiestherouter’sOSPFpriorityinarangefrom0to255.Defaultvalueis
1.
spf‐delay Specifiesthedelay,inseconds,betweenthereceiptofanupdateandtheSPF
execution.Validvaluesare 0 to4294967295.
spf‐hold Specifiestheminimumamountoftime,inseconds,betweentwo
consecutiveOSPFcalculations.Validvaluesare0to4294967295.Avalueof
0meansthattwo
consecutiveOSPFcalculationsareperformedone
immediatelyaftertheother.