Enterasys SecureStack C2

set port broadcast
SecureStack C2 Configuration Guide 5-29
ge.1.1 0 50
ge.1.2 0 50
ge.1.3 0 40
ge.1.4 0 14881
set port broadcast
Usethiscommandtosetthebroadcastsuppressionthreshold,inpacketspersecond,ononeor
moreports.Thissetsathresholdonthebroadcasttrafficthatisreceivedandswitchedouttoother
ports.
Syntax
set port broadcast port-string threshold-val
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleconfiguresports1through5withabroadcastlimitof50pps:
C2(su)->set port broadcast ge.1.1-5 50
clear port broadcast
Usethiscommandtoclearthebroadcastthresholdlimittothedefaultvalueof14881forthe
selectedport.
Syntax
clear port broadcast port-string threshold
Parameters
Defaults
None.
port‐string Selecttheportsforwhichtoconfigurebroadcastsuppressionthresholds.
Foradetaileddescriptionofpossibleport‐stringvalues,referto“Port
StringSyntaxUsedintheCLI”onpage5‐2.
threshold‐val Setsthepacketspersecondthresholdonbroadcasttraffic.Maximum
valueis1488 10for
FastEthernetportsand1488100forGigabitports.
port‐string Selecttheportsforwhichtoclearbroadcastsuppressionthresholds.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage5‐2.