Enterasys SecureStack C2

clear dhcp pool domain-name
SecureStack C2 Configuration Guide 14-25
Syntax
set dhcp pool poolname domain-name domain
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleassignsthe“mycompany.com”domainnametotheaddresspool“auto1.”
C2(rw)->set dhcp pool auto1 domain-name mycompany.com
clear dhcp pool domain-name
Usethiscommandtoremovethedomainnamefromtheaddresspoolbeingconfigured.
Syntax
clear dhcp pool poolname domain-name
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesthedomainnamefromtheaddresspool“auto1.”
C2(rw)->clear dhcp pool auto1 domain-name
set dhcp pool netbios-name-server
UsethiscommandtoassignoneormoreNetBIOSnameserversfortheDHCPclientsservedby
theaddresspoolbeingconfigured.Upto8NetBIOSnameserverscanbeconfigured.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
domain Specifiesthedomain
namestring.Thedomainnamecanbeupto255
charactersinlength.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.