Enterasys SecureStack C2

ip rip enable
SecureStack C2 Configuration Guide 17-3
Example
ThisexampleshowshowtoenableRIP:
C2(su)->router#configure
C2(su)->router(Config)#router rip
C2(su)->router(Config-router)#
ip rip enable
UsethiscommandtoenableRIPonaninterface.ThenoformofthiscommanddisablesRIPonan
interface:Bydefault,RIPisdisabledonallinterfaces.
Syntax
ip rip enable
no ip rip enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableRIPontheVLAN1interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip rip enable
distance
UsethiscommandtoconfiguretheadministrativedistanceforRIProutes.Thenoformofthis
commandresetsRIPadministrativedistancetothedefaultvalueof120.
Syntax
distance weight
no distance [weight]
Parameters
Defaults
None.
Mode
Routerconfiguration:C2(su)‐>router(Config‐router)#
weight SpecifiesanadministrativedistanceforRIProutes.Validvaluesare1‐255.