Enterasys SecureStack C2

clear rmon alarm
SecureStack C2 Configuration Guide 13-11
Example
ThisexampleshowshowtoenableRMONalarmentry3:
C2(rw)->set rmon alarm status 3 enable
clear rmon alarm
UsethiscommandtodeleteanRMONalarmentry.
Syntax
clear rmon alarm index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearRMONalarmentry1:
C2(rw)->clear rmon alarm 1
Event Group Commands
Purpose
TodisplayandclearRMONevents,andtoconfigureRMONeventproperties.
Commands
show rmon event
UsethiscommandtodisplayRMONevententryproperties.
index Specifiestheindexnumberofentrytobecleared.
For information about... Refer to page...
show rmon event 13-11
set rmon event properties 13-12
set rmon event status 13-13
clear rmon event 13-14