Enterasys SecureStack C2

clear rmon history
SecureStack C2 Configuration Guide 13-7
clear rmon history
UsethiscommandtodeleteoneormoreRMONhistoryentriesorresetoneormoreentriesto
defaultvalues.Forspecificvalues,referto“setrmonhistory”onpage 13‐6.
Syntax
clear rmon history {index-list | to-defaults}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodeleteRMONhistoryentry1:
C2(rw)->clear rmon history 1
Alarm Group Commands
Purpose
Todisplay,configure,andclearRMONalarmentriesandproperties.
Commands
show rmon alarm
UsethiscommandtodisplayRMONalarmentries.TheRMONalarmgroupperiodicallytakes
statisticalsamplesfromRMONvariablesandcomparesthemwithpreviouslyconfigured
thresholds.IfthemonitoredvariablecrossesathresholdanRMONeventisgenerated.
index‐list Specifiesoneormorehistoryentriestobedeleted,causingthemto

disappearfromanyfutureRM ONqueries.
to‐defaults Resetsallhistoryentriestodefaultvalues.Thiswillcauseentriesto
reappearinRMONqueries.
For information about... Refer to page...
show rmon alarm 13-7
set rmon alarm properties 13-9
set rmon alarm status 13-10
clear rmon alarm 13-11