Enterasys SecureStack C2

no ip routing
SecureStack C2 Configuration Guide 16-7
Example
ThisexampleshowshowtoenableVLAN1forIProuting:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#no shutdown
no ip routing
UsethiscommandtodisableIProutingonthedeviceandremovetheroutingconfiguration.By
default,IProutingisenabledwheninterfacesareconfiguredforitasde scribedin“Configuring
RoutingInterfaceSettings”onpage 16‐1.
Syntax
no ip routing
Parameters
None.
Mode
Globalconfiguration:C2(su)‐>router(Config)#
Defaults
None.
Example
This example shows how to disable IP routing on the device:
C2(su)->router(Config)#no ip routing
Reviewing and Configuring the ARP Table
Purpose
ToreviewandconfiguretheroutingARPtable,toenableproxyARPonaninterface,andtoseta
MACaddressonaninterface.
Commands
For information about... Refer to page...
show ip arp 16-8
arp 16-9
ip proxy-arp 16-9
arp timeout 16-10
clear arp-cache 16-11