Enterasys SecureStack C2

show gvrp
8-20 802.1Q VLAN Configuration
Purpose
TodynamicallycreateVLANsacrossaswitchednetwork.TheGVRPcommandsetisusedto
displayGVRPconfigurationinformation,thecurrentglobalGVRPstatesetting,individualport
settings(enableordisable)andtimersettings.Bydefault,GVRPisenabledgloballyonthedevice,
butdisabledonallports.
Commands
show gvrp
UsethiscommandtodisplayGVRPconfigurationinformation.
Syntax
show gvrp [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,GVRPconfig urationinformationwillbedisplayedforallportsand
thedevice.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayGVRPstatusforthedeviceandforfw.2.1:
C2(su)->show gvrp ge.2.1
Global GVRP status is enabled.
Port Number GVRP status
----------- -----------
ge.2.1 disabled
For information about... Refer to page...
show gvrp 8-20
show garp timer 8-21
set gvrp 8-22
clear gvrp 8-22
set garp timer 8-23
port‐string (Optional)DisplaysGVRPconfigurationinformationforspecificport(s).For
adetaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐2.