Enterasys SecureStack C2

ip igmp last-member-query-interval
SecureStack C2 Configuration Guide 11-15
ip igmp last-member-query-interval
Usethiscommandtosetthemaximumresponsetimebeinginsertedintogroup‐specificqueries
sentinresponsetoleavegroupmessages.ThenoformofthiscommandresetstheIGMPlast
memberqueryintervaltothedefaultvalueof1 second.
Syntax
ip igmp last-member-query-interval time
no ip igmp last-member-query-interval
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosettheIGMPlastmemberqueryintervalto10secondsonVLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp last-member-query-interval 10
ip igmp last-member-query-count
Usethiscommandtosetthenumberofgroup‐specificqueriessentbeforeassumingthereareno
localmembers.ThenoformofthiscommandresetstheIGMPlastmemberquerycounttothe
defaultvalueof2.
Syntax
ip igmp last-member-query-count count
no ip igmp last-member-query-count
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
time SpecifiestheIGMPlastmemberqueryinterval.Validvaluesarefrom0to
255seconds.Thedefaultvalueis1second.
count SpecifiesthenumberofIGMPstartupqueries.Validvaluesarefrom1to
20.Thedefaultvalueis2.