Enterasys SecureStack C2

clear dhcp pool next-server
SecureStack C2 Configuration Guide 14-21
Mode
Switchcommand,read‐write.
Example
Thisexamplespecifiesthefileserverfromwhichclientsbeingservedbyaddresspool“auto1”
shoulddownloadthebootimagefile“image1.img.”
C2(rw)->set dhcp pool auto1 bootfile image1.img
C2(rw)->set dhcp pool auto1 next-server 10.1.1.10
clear dhcp pool next-server
Usethiscommandtoremovethebootimagefileserverfromtheaddresspoolbeingconfigured.
Syntax
clear dhcp pool poolname next-server
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesthefileserverfromaddresspool“auto1.”
C2(rw)->clear dhcp pool auto1 next-server
set dhcp pool lease
UsethiscommandtospecifythedurationoftheleaseforanIPaddressassignedbytheDHCP
serverfromtheaddresspoolbeingconfigured.
Syntax
set dhcp pool poolname lease {days [hours [minutes]] | infinite}
Parameters
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
all (Optional)Clearsuser‐definedconfigurationparameters(andstackunit
numbersandpriorities,ifapplicable).
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
days Specifiesthenumberofdaysanaddressleasewillremainvalid.Value
canrangefrom0to59.