Enterasys SecureStack C2

clear dhcp pool netbios-name-server
14-26 DHCP Server Configuration
Syntax
set dhcp pool poolname netbios-name-server address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleassignsaNetBIOSnameserverat10.15.10.1totheaddresspoolbeingconfigured.
C2(rw)->set dhcp pool auto1 netbios-name-server 10.15.10.1
clear dhcp pool netbios-name-server
UsethiscommandtoremovetheNetBIOSnamerserverlistfromtheaddresspoolbeing
configured.
clear dhcp pool poolname netbios-name-server
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleremovestheNetBIOSnameserverlistfromtheaddresspoolauto1.
C2(rw)->clear dhcp pool auto1 netbios-name-server
set dhcp pool netbios-node-type
UsethiscommandtospecifyaNetBIOSnode(server)typefortheDHCPclientsservedbythe
addresspoolbeingconfigured.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
address SpecifiestheIPaddressofaNetBIOSnameserver.
address2...address8
(Optional)Specifies,inorderofpreference,upto7additionalNetBIOS
nameserveraddresses.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.