Enterasys SecureStack C2

show running-config
16-6 IP Configuration
show running-config
Usethiscommandtodisplaythenon‐default,user‐suppliedcommandsenteredwhileconfiguring
thedevice.
Syntax
show running-config
Parameters
None.
Defaults
None.
Mode
Anyroutermode.
Example
Thisexampleshowshowtodisplaythecurrentrouteroperatingconfiguration:
C2(su)->router#show running-config
!
interface vlan 10
ip address 99.99.2.10 255.255.255.0
no shutdown
!
router ospf 1
network 99.99.2.0 0.0.0.255 area 0.0.0.0
network 192.168.100.1 0.0.0.0 area 0.0.0.0
no shutdown
UsethiscommandtoenableaninterfaceforIProutingandtoallowtheinterfacetoautomatically
beenabledatdevicestartup.
Syntax
no shutdown
shutdown
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Usage
TheshutdownformofthiscommanddisablesaninterfaceforIProuting.