Enterasys SecureStack C2

set radius accounting
18-8 Security Configuration
Mode
Switchcommand,read‐only.
Defaults
Ifnoparametersarespecified,allRADIUSaccountingconfigurationinformationwillbe
displayed.
Example
ThisexampleshowshowtodisplayRADIUSaccountingconfigurationinformation.Inthiscase,
RADIUSaccountingisnotcurrentlyenabledandglobaldefaultsettingshavenotbeenchanged.
Oneserverhasbeenconfigured.
FordetailsonenablingandconfiguringRADIUSaccounting,referto“setradiusaccounting”on
page 18‐8:
C2(ro)->show radius accounting
RADIUS accounting status: Disabled
RADIUS Acct Server IP Address Acct-Port Retries Timeout Status
------------------ ---------- --------- ------- ------- ------
1 172.16.2.10 1856 3 20 Disabled
set radius accounting
UsethiscommandtoconfigureRADIUSaccounting.
Syntax
set radius accounting {[enable | disable] [retries retries] [timeout timeout]
[server ip_address port [server-secret]
Parameters
Mode
Switchcommand,read‐write.
Defaults
None.
enable|disable EnablesordisablestheRADIUSaccountingclient.
retriesretries SetsthemaximumnumberofattemptstocontactaspecifiedRADIUS
accountingserverbeforetimingout.Validretryvaluesare0‐10.
timeouttimeout Setsthemaximumamountoftime(inseconds)toestablishcontactwitha
specifiedRADIUS
accountingserverbeforetimingout.Validtimeout
valuesare1‐30.
serverip _address
portserver‐secret
Specifiestheaccountingserver’s:
•IPaddress
•UDPauthenticationport(0‐65535)
• server‐secret(Read‐Writepasswordtoaccessthisaccountingserver.
Devicewillpromptforthisentryuponcreatingaserverinstance,as
shownin
theexamplebelow.)