Enterasys SecureStack C2

Configuring Node Aliases
12-32 Logging and Network Management
Configuring Node Aliases
Purpose
Toreview,disable,andre‐enablenode(port)aliasfunctionality,which determineswhatnetwork
protocolsarerunningononeormoreports.
Commands
show nodealias config
Usethiscommandtodisplaynodealiasconfigurationsettingsononeormoreports.
Syntax
show nodealias config [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,nodealiasconfigurationswillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaynodealiasconfigurationsettingsforportsge.2.1through9:
C2(rw)->show nodealias config ge.2.1-9
Port Number Max Entries Used Entries Status
----------- ----------- ------------ ------
ge.2.1 16 0 Enable
ge.2.2 47 0 Enable
ge.2.3 47 2 Enable
ge.2.4 47 0 Enable
ge.2.5 47 0 Enable
ge.2.6 47 2 Enable
ge.2.7 47 0 Enable
ge.2.8 47 0 Enable
ge.2.9 4000 1 Enable
Table 12‐7providesanexplanationofthecommandoutput.
For information about... Refer to page...
show nodealias config 12-32
set nodealias 12-33
clear nodealias config 12-34
port‐string (Optional)Displaysnodealias conf igurationsettingsforspecificport(s).