Enterasys SecureStack C2

Using the Command Line Interface
1-6 Introduction
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
ConnectaterminaltothelocalconsoleportasdescribedinyourSecureStackC2InstallationGuide.
Thestartupscreen,Figure 1‐1,willdisplayontheterminal.YoucannowstarttheCommandLine
Interface(CLI)by
•usingadefaultuseraccount,asdescribedin“UsingaDefaultUserAccount”
onpage 1‐7,or 
•usinganadministratively‐assigneduseraccountasdescribedin“UsinganAdministratively
ConfiguredUserAccount”onpage 1‐7.
Figure 1-1 SecureStack C2 Startup Screen
Connecting Using Telnet
OncetheSecureStackC2devicehasavalidIPaddress,youcanestablishaTelnetsessionfromany
TCP/IPbasednodeonthenetwork.Forinformationaboutsettingtheswitch’sIPaddress,referto
“setipaddress”onpage 3‐9.
Telnet Enabled.
Telnet port (IP) Set to port number 23.
Timers (OSPF) SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Transmit delay (OSPF) Set to 1 second.
VRRP Disabled.
Table 1-1 Default Settings for Basic Switch and Router Operation (Continued)
Feature Default Setting
Username:admin
Password:
Enterasys SecureStack C2
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2006
Chassis Serial Number: 041800249041
Chassis Firmware Revision: 5.1.xx
C2(su)->