Enterasys SecureStack C2

clear spantree legacypathcost
SecureStack C2 Configuration Guide 7-31
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Bydefault,legacypathcostisdisabled.Enablingthedevicetocalculatelegacypathcostsaffects
therangeofvalidvaluesthatcanbeenteredinthesetspantreeadminpathcostcommand.
Example
Thisexampleshowshowtosetthedefaultpathcostvaluesto802.1D.
C2(rw)->set spantree legacypathcost enable
clear spantree legacypathcost
UsethiscommandtosettheSpanningTreedefaultvalueforlegacypathcostto802.1tvalues.
Syntax
clear spantree legacypathcost
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleclearsthelegacypathcostto802.1tvalues.
C2(rw)->clear spantree legacypathcost
Configuring Spanning Tree Port Parameters
Purpose
TodisplayandsetSpanningTreeportparameters.
disable Use802.1t2001valuestocalculatepathcost.
enable Use802.1d1998valuestocalculatepathcost.