Enterasys SecureStack C2 User Manual

set sntp client
SecureStack C2 Configuration Guide 12-27
set sntp client
UsethiscommandtosettheSNTPoperationmode.
Syntax
set sntp client {broadcast | unicast | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenableSNTPinbroadcastmode:
C2(su)->set sntp client broadcast
clear sntp client
UsethiscommandtocleartheSNTPclient’soperationalmode.
Syntax
clear sntp client
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheSNTPclient’soperationalmode:
C2(su)->clear sntp client
broadcast EnablesSNTPinbroadcastclientmode.
unicast EnablesSNTPinunicast(point‐to‐point)clientmode.Inthismode,the
clientmustsupplytheIPaddressfromwhichtoretrievethecurrenttime.
disable DisablesSNTP.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English