Enterasys SecureStack C2

Statistics Group Commands
SecureStack C2 Configuration Guide 13-3
Statistics Group Commands
Purpose
Todisplay,configure,andclearRMONstatistics.
Commands
show rmon stats
UsethiscommandtodisplayRMONstatisticsmeasuredforoneormoreports.
Syntax
show rmon stats [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,RMONstatswillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONstatisticsforGigabitEthernetport1inswitch1.
:
C2(su)->show rmon stats ge.1.1
Port: ge.1.1
-------------------------------------
Index = 1
Owner = monitor
Data Source = ifIndex.1
Drop Events = 0 Packets = 0
Collisions = 0 Octets = 0
Jabbers = 0 0 - 64 Octets = 0
Broadcast Pkts = 0 65 - 127 Octets = 0
Note: Due to hardware limitations, the only frame error counted is oversized frames.
For information about... Refer to page...
show rmon stats 13-3
set rmon stats 13-4
clear rmon stats 13-4
port‐string (Optional)DisplaysRMONstatisticsforspecificport(s).