Enterasys SecureStack C2 User Manual

SecureStack C2 Configuration Guide 16-1
16
IP Configuration
ThischapterdescribestheInternetProtocol(IP)configurationsetofcommandsandhowtouse
them.
Configuring Routing Interface Settings
Purpose
Toenableroutinginterface conf igurationmodeonthedevice,tocreateroutinginterfaces,to
reviewtheusabilitystatusofinterfacesconfiguredforIP,tosetIPaddressesforinterfaces,to
enableinterfacesforIProutingatdevicestartup,andtoreviewtherunningconfiguration.
Commands
Router: Unless otherwise noted, the commands covered in this chapter can be executed only
when the device is in router mode. For details on how to enable router configuration modes, refer
to “Enabling Router Configuration Modes” on page 15-2.
For information about... Refer to page...
Configuring Routing Interface Settings 16-1
Reviewing and Configuring the ARP Table 16-7
Configuring Broadcast Settings 16-11
Reviewing IP Traffic and Configuring Routes 16-13
For information about... Refer to page...
show interface 16-2
interface 16-2
show ip interface 16-4
ip address 16-5
show running-config 16-6
no shutdown 16-6
no ip routing 16-7

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English