set port ratelimit
SecureStack C2 Configuration Guide 10-11
set port ratelimit
Usethiscommandtoconfigurethetrafficratelimitingstatusandthreshold(inkilobytesper
second)foroneormoreports.
Syntax
set port ratelimit {disable | enable} | port-string priority threshold
{disable | enable} [inbound] [index]
Parameters
Defaults
Thresholdwillbeappliedtoinboundtrafficontheport/priority.
Ifindexisnotspecified,settingswillbeappliedtoindex1,and willoverwriteindex1forany
subsequentratelimitsconfigured.
Mode
Switchcommand,read‐write.
Index Resource index for this port.
Threshold (kB/s) Port rate limiting threshold in kilobytes per second.
Action Whether or not frames not conforming to rate limiting will be discarded.
Direction Currently rules can only be applied to inbound traffic.
Priority List 802.1D (802.1p) port priority level.
Status Whether or not this rule is active or disabled.
Table 10-1 show port ratelimit Output Details (Continued)
Output What It Displays...
disable|enable Whenenteredwithoutaport‐string,globallydisablesorenablestheport
ratelimitingfunction.Whenenteredwithaport‐string,disablesor
enablesratelimitingonspecificport(s)whentheglobalfunctionis
enabled.
port‐string Specifiesaportonwhichtosettheratelimitingthreshold
andother
parameters.Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedintheCLI”onpage 5‐2.
priority Specifiesthe802.1D(802.1p)portprioritylevelassociatedwiththeport‐
string.Thevaluecanbe0to7,with0specifyingthelowestpriority.
threshold Specifiesaportratelimitingthresholdinkilobytespersecond.Rangeis
64uptoamaximumof2,14 7,483,647kilobytespersecond.
inbound (Optional)Appliesthisratepolicingruletoinboundtraffic.
index (Optional)Assignsaresourceindexforthisport.
To Next Page
Loading...
Need help?
General