Enterasys SecureStack C2

router vrrp
SecureStack C2 Configuration Guide 17-39
router vrrp
UsethiscommandtoenableordisableVRRPconfigurationmode.Thenoformofthiscommand
removesallVRRPconfigurationsfromtherunningconfiguration.
Syntax
router vrrp
no router vrrp
Parameters
None.
Defaults
None.
Mode
Globalconfiguration:C2(su)‐>router(Config)#
Usage
Youmustexecutetheroutervrrpcommandtoenabletheprotocolbeforecompletingother
VRRP‐specificconfigurationtasks.Fordetailsonenablingconfigurationmodes,referto
Table 15‐2in“EnablingRouterConfigurationModes”onpage15‐2.
Example
ThisexampleshowshowenableVRRPconfigurationmode:
C2(su)->router#configure
C2(su)->router(Config)#router vrrp
C2(su)->router(Config-router)#
create
UsethiscommandtocreateaVRRPsession.EachSecureStackC2systemsupportsupto20VRRP
sessions.ThenoformofthiscommanddisablestheVRRPsession.
Syntax
create vlan vlan-id vrid
no create vlan vlan-id vrid
preempt 17-42
enable 17-43
show ip vrrp 17-44
For information about... Refer to page...