Enterasys SecureStack C2

set rmon event status
SecureStack C2 Configuration Guide 13-13
Parameters
Defaults
Ifdescriptionisnotspecified,nonewillbeapplied.
Ifnotspecified,typenonewillbeapplied.
Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateandenableanRMONevententrycalled“STPtopology
change”thatwillsendbothalogentryandanSNMPtrapmessagetothe“public”community:
C2(rw)->set rmon event properties 2 description "STP topology change" type both
community public owner Manager
set rmon event status
UsethiscommandtoenableanRMONevententry.Anevententrydescribestheparametersofan
RMONeventthatcanbetri ggered.EventscanbefiredbyRMONalarmsandcanbeconfiguredto
createalogentry, generateatrap,orboth.
Syntax
set rmon event status index enable
Parameters
Defaults
None.
index Specifiesanindexnumberforthisentry.Maximumnumberofentriesis
100.Maximumvalueis65535.
description
description
(Optional)Specifiesatextstringdescriptionofthisevent.
typenone|log|
trap|both
(Optional)SpecifiesthetypeofRMONeventnotificationas:none,alog
tableentry,an
SNMPtrap,orbothalogentryandatrapmessage.
community
community
(Optional)SpecifiesanSNMPcommunitynametouseifthemessage
typeissettotrap.FordetailsonsettingSNMPtrapsandcommunity
names,referto“CreatingaBasicSNMPTrapConfiguration”on
page 6‐36.
ownerowner
(Optional)Specifiesthenameoftheentitythatconfiguredthisentry.
index Specifiesanindexnumberforthisentry.Maximumnumberofentriesis
100.Maximumvalueis65535.
enable Enablesthisevententry.