Enterasys SecureStack C2

clear policy profile
SecureStack C2 Configuration Guide 9-5
clear policy profile
Usethiscommandtodeleteapolicyprofileentry.
Syntax
clear policy profile profile-index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodeletepolicyprofile8:
C2(su)->clear policy profile 8
Configuring Classification Rules
Purpose
Toreview,create,assign,andunassignclassificationrulestopolicyprofiles.Thismapsuser
profilestoprotocol‐basedframefilteringpolicies.
Commands
show policy rule
Usethiscommandtodisplaypolicyclassificationruleinformation.
profile‐index Specifiestheindexnumberoftheprofileentrytobedeleted.Validvalues
are1to255.
Note: B3, C3, and G3 devices support profile-based CoS traffic rate limiting only. Policy rules
specifying CoS will not rate limit on these devices, or on mixed stacks including B3 or C3 devices.
For information about... Refer to page...
show policy rule 9-5
show policy capability 9-8
set policy rule 9-9
clear policy rule 9-12
clear policy all-rules 9-13