To Next Page

To Previous Page

show ip pimsm rp

17-52 IPv4 Routing Protocol Configuration

Parameters

Defaults

None.

Mode

Anyroutermode.

Examples

ThisexampleshowshowtodisplaytheRPsetforaspecificgroupaddress.

C2(su)->router> show ip pimsm rp 224.0.0.0 240.0.0.0

RP SET TABLE

Group

Address Group Mask Address Hold Time Expiry Time Component C-RP Priority

(hh:mm:ss) (hh:mm:ss)

--------- ---------- ----------- ---------- ----------- --------- -----------

224.0.0.0 240.0.0.0 192.168.30.2 00:02:15 00:02:30 1 0

Table 17‐12providesanexplanationofthecommandoutput.

ThisexampleshowshowtodisplaythecandidateRPsforeachgroupaddress.

C2(su)->router> show ip pimsm rp candidate

CANDIDATE RP TABLE

Group Address Group Mask Address

--------------- --------------- ---------------

224.0.0.0 240.0.0.0 192.168.30.2

group‐address ThemulticastgroupIPaddress.

group‐mask Themulticastgroupaddresssubnetmask.

all Forallknowngroupaddresses.

candidate DisplayPIM‐SMcandidate‐RPtableinformation.

Table 17-12 show ip pimsm rp Output Detail

Output What it displays

Group Address The address of the group for which the RP set is displayed.

Group Mask The mask of the group address.

Address The IP address of the RP.

Hold Time The hold time of the RP.

Expiry Time The minimum time remaining before the RP will be declared down.

Component A number which uniquely identifies the component. Each protocol instance

connected to a separate domain should have a different index value.

C-RP Priority The candidate-RP priority of the RP.

Enterasys SecureStack C2 User Manual

Questions and Answers: