Enterasys SecureStack C2

ip ospf retransmit-interval
17-16 IPv4 Routing Protocol Configuration
ip ospf retransmit-interval
Usethiscommandtosettheamountoftimebetweenretransmissionsoflinkstateadvertisements
(LSAs)foradjacenciesthatbelongtoaninterface.Thenoformofthiscommandresetsthe
retransmitintervalvaluetothedefault,5seconds.
Syntax
ip ospf retransmit-interval seconds
no ip ospf retransmit-interval
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosettheOSPFretransmitintervalfortheVLAN1interfaceto20:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip ospf retransmit-interval 20
ip ospf transmit-delay
Usethiscommandtosettheamountoftimerequiredtotransmitalinkstateupdatepacketonan
interface.Thenoformofthiscommandresetstheretransmitintervalvaluetothedefault,1
second.
Syntax
ip ospf transmit-delay seconds
no ip ospf transmit-delay
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
seconds Specifiestheretransmittimeinseconds.Validvaluesare1to65535.
seconds Specifiesthetransmitdelayinseconds.Validvaluesarefrom1to65535.