Enterasys SecureStack C2 - Clear Eapol

clear eapol
18-18 Security Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtoenableEAPOL:
C2(su)->set eapol enable
ThisexampleshowshowtoenableEAPOLwithforcedauthorizedmodeonportge.1.1:
C2(su)->set eapol auth-mode forced-auth ge.1.1
clear eapol
UsethiscommandtogloballycleartheEAPOLauthenticationmode,ortoclearsettingsforoneor
moreports.
Syntax
clear eapol [auth-mode] [port-string]
Parameters
Defaults
Ifauth‐modeisnotspecified,allEAPOLsettingswillbecleared.
Ifport‐stringisnotspecified,settingswillbeclearedforallports.
enable|disable EnablesordisablesEAPOL.
auth‐mode
auto|
forced‐auth|
forced‐unauth
Specifiestheauthenticationmodeas:
• auto‐Autoauthorizationmode.Thisisthedefault
modeandwill
forwardframesaccordingtotheauthenticationstateoftheport.For
detailsonthismode,refertoTable 18‐2.
• forced‐auth‐Forcedauthorizedmode,whichdisablesauthentication
ontheport.
• forced‐unauth‐Forcedunauthorizedmode,whichfiltersanddiscards
allframesreceivedontheport.
port‐string
Specifiestheport(s)onwhichtosetEAPOLparameters.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 5 ‐2.
auth‐mode (Optional)GloballyclearstheEAPOLauthenticationmode.
port‐string Specifiestheport(s)onwhichtoclearEAPOLparameters.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 5‐2.