Enterasys SecureStack C2

set linkflap portstate
5-24 Port Configuration
set linkflap portstate
Usethiscommandtoenableordisablelinkflapmonitoringononeormoreports.
Syntax
set linkflap portstate {disable | enable} [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,allportsareenabledordisabled.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoenablethelinktrapmonitoringonallports.
C2(rw)->set linkflap portstate enable
set linkflap interval
Usethiscommandtosetthetimeinterval(inseconds)foraccumulatinglinkdowntransitions.
Syntax
set linkflap interval port-string interval-value
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthelinkflapintervalonportge.1.4to1000seconds.
C2(rw)->set linkflap interval ge.1.4 1000
disable|enable Disablesorenablesthelinkflapdetectionfunction.
port‐string (Op tional)Specifiestheportorportsonwhichtodisableorenable
monitoring.
port‐string Specifiestheport(s)onwhichtosetthelinkflapinterval.
interval‐value Specifiesanintervalinseconds.Avalueof0willsettheintervalto
forever.