Enterasys SecureStack C2

show spantree mstilist
7-12 Spanning Tree Configuration
show spantree mstilist
UsethiscommandtodisplayalistofMultipleSpanningTree(MST)instancesconfiguredonthe
device.
Syntax
show spantree mstilist
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayalistofMSTinstances.Inthiscase,SID2hasbeenconfigured:
C2(su)->show spantree mstilist
Configured Multiple Spanning Tree instances:
2
set spantree msti
UsethiscommandtocreateordeleteaMultipleSpanningTreeinstance.
Syntax
set spantree msti sid sid {create | delete}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateanMSTinstance2:
C2(su)->set spantree msti sid 2 create
sidsid SetstheMultipleSpanningTreeID.Validvaluesare1‐4094.
SecureStackC2deviceswillsupportupto4MSTinstances.
create|delete CreatesordeletesanMSTinstance.