Enterasys SecureStack C2

Setting Basic Switch Properties
3-8 Basic Configuration
Setting Basic Switch Properties
Purpose
TodisplayandsetthesystemIPaddressandotherbasicsystem(switch)properties.
Commands
Thecommandsusedtosetbasicsysteminformationarelistedbelow.
For information about... Refer to page...
show ip address 3-9
set ip address 3-9
clear ip address 3-10
show ip protocol 3-10
set ip protocol 3-11
show system 3-11
show system hardware 3-12
show system utilization 3-13
set system enhancedbuffermode 3-14
show time 3-15
set time 3-15
show summertime 3-16
set summertime 3-16
set summertime date 3-17
set summertime recurring 3-17
clear summertime 3-18
set prompt 3-19
show banner motd 3-19
set banner motd 3-20
clear banner motd 3-20
show version 3-21
set system name 3-22
set system location 3-22
set system contact 3-23
set width 3-23
set length 3-24
show logout 3-24
set logout 3-25