Enterasys SecureStack C2

show port ratelimit
10-10 Port Priority and Rate Limiting Configuration
Commands
.
show port ratelimit
Usethiscommandtoshowthetrafficratelimitingconfigurationononeormoreports.
Syntax
show port ratelimit [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,ratelimitinginformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythecurrentratelimitinginformationforge.2.1:
C2(su)->show port ratelimit ge.2.1
Global Ratelimiting status is disabled.
Port Threshold Priority
Number Index (kB/s) Action Direction List Status
----------- ----- --------- ------------ --------- ----------- --------
ge.2.1 1 64 discard inbound 0 disabled
ge.2.1 2 64 discard inbound 0 disabled
ge.2.1 3 64 discard inbound 0 disabled
ge.2.1 4 64 discard inbound 0 disabled
ge.2.1 5 64 discard inbound 0 disabled
ge.2.1 6 64 discard inbound 0 disabled
ge.2.1 7 64 discard inbound 0 disabled
ge.2.1 8 64 discard inbound 0 disabled
Table 10‐1providesanexplanationofthecommandoutput.
For information about... Refer to page...
show port ratelimit 10-10
set port ratelimit 10-11
clear port ratelimit 10-12
port‐string (Optional)Displaysratelimitinginformationforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐2.
Table 10-1 show port ratelimit Output Details
Output What It Displays...
Port Number Port designation. For a detailed description of possible port-string
values, refer to “Port String Syntax Used in the CLI” on page 5-2.